Hello ECF,
I remember when i first started vaping, this community was there to help me through the learning curve. Welp the learning curve has once again appeared.
I have started to venture into the world of Temperature control. I couldnt wait to see what it was like.
I bought the new sigelei Fuchai with TC and calculated a build that would come out to about .06 ohms when the wires are cool. ( Yes I am locking the resistance)
My build: 26ga Nickle wire / 16 wraps each around a 3mm bit ( dual coil )
My problem: There is almost no way that this build is reaching the target temperature. The ramp up time is longer than anything i have ever experienced. The vape is way too cool for my taste no matter what temperature i set this at.
The only solution i have found so far... is if i lock the resitance after firing the coil the resistance will be a little higher (a .06 ohm build will be locked at a .07 or .10 ohm at most). This for some reason will lead to a more satisfying vape but i have no idea if this is opening me up to any potential hazards in terms of abusing the hardware. I need someone advise on this specifically as well
This mod is supposed to adjust the wattage/volt automatically according to what temperature setting you put it on so it does not have wattage/joules control while in tc mode.
Please halp!!
I remember when i first started vaping, this community was there to help me through the learning curve. Welp the learning curve has once again appeared.
I have started to venture into the world of Temperature control. I couldnt wait to see what it was like.
I bought the new sigelei Fuchai with TC and calculated a build that would come out to about .06 ohms when the wires are cool. ( Yes I am locking the resistance)
My build: 26ga Nickle wire / 16 wraps each around a 3mm bit ( dual coil )
My problem: There is almost no way that this build is reaching the target temperature. The ramp up time is longer than anything i have ever experienced. The vape is way too cool for my taste no matter what temperature i set this at.
The only solution i have found so far... is if i lock the resitance after firing the coil the resistance will be a little higher (a .06 ohm build will be locked at a .07 or .10 ohm at most). This for some reason will lead to a more satisfying vape but i have no idea if this is opening me up to any potential hazards in terms of abusing the hardware. I need someone advise on this specifically as well
This mod is supposed to adjust the wattage/volt automatically according to what temperature setting you put it on so it does not have wattage/joules control while in tc mode.
Please halp!!
