problems with my kangertech

[MrLarner]

I got a kangertech from a friend, it was only 3 days old and he didn't want it, so i received it.
it's been perfectly fine for a few days until the juice run low, so i emptied the remaining and filled it up with a new bubblegum juice.
as soon as i refilled it.
my readings on the LCD are......
0.0v
9.9Q (which keeps flashing)
24.0W

why is the 9.9Q flashing and what does it mean?
i cant take a pull on the kangertech either.
someone please help

 

[MattyVigilante]

Your mod is not recognising that an atomiser is attached, that's why it isn't reading the ohms of the coil, is everything attached properly?

 

[Completely Average]

Kangertech sells a lot of products. It's a company name, not the name of any specific mod or tank. In the future it would help you a lot to know exactly which mod and tank you have, especially when it comes time to buy replacement coils.

Now, that said, your "9.9Q" error means there is an open circuit. It's not seeing the atomizer.

The two most common causes if this is you either unscrewed the coil slightly and it's not making contact with the base of the tank anymore, or you didn't screw the tank into the mod far enough for it to make contact with the 510 pin. The way to fix this is to take the tank off the mod and open it up like you were going to refill it. The coil should be sticking out of the base of the tank. Give it a twist to try to tighten it up. You don't want to torque it down, but you do want to make sure it's tight enough to be nice and snug. Then put the tank back together and screw it on the mod and tighten it enough to be snug. Again, you don't want to torque it down really hard, but you do want to make sure it's nice and snug.

If you're still having problems, find out exactly what mod and tank you have and come back. We're more than happy to help, but we will need to know what specific gear you have to give you the right advice.

 

[MattyVigilante]

Kangertech sells a lot of products. It's a company name, not the name of any specific mod or tank. In the future it would help you a lot to know exactly which mod and tank you have, especially when it comes time to buy replacement coils.

Now, that said, your "9.9Q" error means there is an open circuit. It's not seeing the atomizer.

The two most common causes if this is you either unscrewed the coil slightly and it's not making contact with the base of the tank anymore, or you didn't screw the tank into the mod far enough for it to make contact with the 510 pin. The way to fix this is to take the tank off the mod and open it up like you were going to refill it. The coil should be sticking out of the base of the tank. Give it a twist to try to tighten it up. You don't want to torque it down, but you do want to make sure it's tight enough to be nice and snug. Then put the tank back together and screw it on the mod and tighten it enough to be snug. Again, you don't want to torque it down really hard, but you do want to make sure it's nice and snug.

If you're still having problems, find out exactly what mod and tank you have and come back. We're more than happy to help, but we will need to know what specific gear you have to give you the right advice.

I wish I could have worded my response as concisely as that however I'm typing on a tablet and probably would have still been here tomorrow XD

 

[BrotherBob]

Welcome and glad you joined.

 

[Down-Time]

If all else fails, shut it off and turn it back on. My Kbox mini does this too. After you turn it back on it will either recognize the correct ohm or ask you if it's a new atomizer.

 

[suprtrkr]

Hi and welcome. +1, the mod is not seeing the topper for some reason.