Help with BlackBerry

Status
Not open for further replies.

sketch804

Senior Member
ECF Veteran
Verified Member
Dec 11, 2014
194
146
Okay so I am new to DIY, I have made a good few flavors that have become my ADV's, but the one I cannot figure out, BlackBerry. My usual ADV that I go back to again and again is mount baker Vapor BlackBerry, but I cannot recreate it out even get near that flavor. I have used TFA, Capella, and Lorann and all taste nothing like a decent BlackBerry. TFA is okay but a very flat flavor IMO. I usually make light % for flavors so most of my tries have been between 5-10%, 80vg\20pg. Not a fan of the heavy flavors but a nice light BlackBerry shouldn't be that hard to find. Any help would be much appreciated, thanks!
 

EverPresentNoob

Ultra Member
ECF Veteran
Verified Member
Apr 2, 2015
1,064
1,879
DC Metro area
I use the TFA blackberry. no clue the amount I mixed into a 30ml batch, but I started with 1ml flavor and slowly added drops until I got the flavor I wanted. I tried 10% flavor initially and it was to strong and a touch chemically. so now I start low and add drops slowly, heating, shaking and then cooling and vaping until I get the flavor I want. Once this mixed bottle is gone (should be tomorrow) I and going to take a measured amount of flavoring in a separate small jar and then mix my 30ml batch my way. then I will measure how much flavoring is left to know how much I actually used.
 

satchvai

Super Member
ECF Veteran
Jul 16, 2015
472
1,089
57
Off the grid
I would suggest with your TFA flavors that you mix them with creams and sweeteners to bring out their potential. there is a whole thread devoted to TFA flavors and that is one of the key things. Think of it as if you were eating blackberries for real. You'd add sugar and cream. Same concept with TFA flavors.
 
  • Like
Reactions: sattv
Status
Not open for further replies.

Users who are viewing this thread