Enlarging stainless steel atomiser drip tip hole

[rebuilder]

I'm looking at 2 Hellfires and a Line V2. I have about 7-8 drip tips that work perfectly on cartos, and a number of other rebuildable atomisers however the Hellfire and Line are annoyingly small and I have to either use a plastic/rubber drip tip to fir or jam the bottom of a ss drip tip without the o-ring being able to slide in.

I've been looking at all sorts of options and either discarding them or realising I can't find enough info to justify carrying it through, from drill bits to coarse polishing compounds with a rotary tool (I have no idea what to look for), to even one i tried (wet and dry paper duct taped on to a drill attachment, this made the slightest noticeable impact after a number of changes of paper). Can somebody please help me find specific products, I have a drill and I can buy a cheap rotary tool and the specific attachment(s) I need to do this if necessary.

 

[Robert T]

Ask this at vapepit, they have a lot of info on the Hellfire.

http://web77.extendcp.co.uk/vapepit.com/

 

[TheVap3Junkie]

the small sanding and grinding bits for rotary tools will chuck up in a drill you could just buy some rotary tool accessories. No need to buy a rotary tool if not needed although they do come in handy for a lot of stuff. The small sanding bit may be better but this would work too.

Shop Dremel 2-Count Aluminum Oxide Grinding Bits at Lowes.com

 

[rebuilder]

Thanks for your help guys. TheVap3Junkie that was exactly what I was after, have found a few uk sources for aluminium oxide bits so will report back with results for future reference.

 

[dsy5]

If I'm understanding correctly, you want to open the holes in the attys. Get yourself some titanium or carbon steel drill bits. Use the lowest speed possible to adequately remove the material. The harder the metal, usually, lower the rpms.