Diy 18350 battery holder???

[qdaddy96]

Any ideas? Im trying to make a battery holder for a 18350 battery sumthing were i can fit a battery in with two metal ends with + and - wire??? Just need some ideas!

 

[Skyfntm]

Could use a battery storage box, wood, acrylic, cardboard, PVC, toothbrush, tampon. Anything really!!

 

[qdaddy96]

Thanks liking the tampon idea ?

Sent from my LG-MS770 using Tapatalk

 

[qdaddy96]

Lol but seems simple anough

Sent from my LG-MS770 using Tapatalk

 

[Skyfntm]

Lol but seems simple anough

Sent from my LG-MS770 using Tapatalk

It is very simple. Just don't use anything metal. That won't work.

 

[arth_d]

I used an 18650 one and cut out the middle section and glued it together.

 

[Nomoreash]

I used an 18650 one and cut out the middle section and glued it together.

Ditto, same here. Probably not the most cost effective or quickest solution if not already in hand but I found definitely the easiest. Just cut a 30mm section from the middle, glue the ends together then glue to the box and it's not going anywhere.

Error on the side of to long if you're doing this, maybe cut 25mm and file down from there if needed. You can always take a little bit off to shorten, it's harder to add length.