Adding WTA to DIY E-Juice for Sub-Ohm Tanks

[Treeburner1983]

I've been making my own juice for over six months now, and have settled on a few flavors I love. I've cut back to 6mg/ml nicotine in my juice, but would like to try WTA.

Ordered some 24mg unflavored WTA juice from Aroma E-Juice, but I'm reading conflicting suggestions as to where to start, and much of the information is about using cartos or other low-voltage tanks. I'm using TC mods with dual nickel coils and producing significant vapor, so the suggestion of adding a certain number of drops to a carto does me no good.

So, at what percentage should I add the 24mg WTA to my 6mg/ml juice? 5%? 10%? Not going to be vaping the WTA all day but will have a tank setup for the morning and after work so I'm not worried about overdoing it, just don't want to waste the expensive WTA. Suggestions?

Thanks,
Treeburner

 

[dannyv45]

Start at 5% and go up from there. I've actually vaped a 12mg mothers milk WTA straight but it all depends on how much of a tobacco fan you are.

 

[Treeburner1983]

Thanks for the suggestion, was hoping 5% would be enough. At that % the 30ml I ordered will last me and my fiancée a long time since we've both been off cigs for almost 9 months.

Will be mixing it with my standard ADV of max VG Espresso, should compliment the flavor nicely from what I've read about WTA.

-Treeburner

 

[township]

You might want to start at 10%. Aroma's WTA is easier to underdo than overdo.

When you've had enough, you'll put it down. If you mix it too weak, you might not "feel the benefit."

Good luck